Search results

Sorry, Richie. No help on the parts you need.

Is that the same "knob" that is on the temperature control and the heater/AC control?

65BLUBIRD: Please clarify "knob for vent switch"

For O.F. and any others that might be interested. I have two (2) NOS & NIB back up body assys (C5SZ-15512-A) will fit either left or right, two lense NOS & NIB along with two fairly good doors all in one lot. Asking $50 plus $7.50 postage. Ready to package and send. 9will fit either...

NOT back up lights........... I apologize to everyone for having a "senior moment". The lights I have listed for sale are PARKING LIGHTS, not back up lights. I DO know the difference! I do, however, have new Ford packaged lenses for back up lights (1964 and1965) for anyone needing or wanting...

Two good back up lights for '64 or '65 Thunderbird. Good lamp bodies, good lenses, good wires. Asking $20.00 plus postage.

Closing vintage Thunderbird restoration shop due to bad health. What do you need (or want)? New ,use and rebuildable. Carpet sets, trunk liners, 61-63 conv package trays, prof. rebuilt 65,66 water pump, switches, relays, 62-65 Landau black vinyl top, 66 gold Landau & THT headliner,58-60 conv...

Originally, Ford installed a group 27 battery, which is 12 inches long.

I don't think the valves would be leaking. I would suspect the valve seals.

Sorry to say... I don't know what an "apron assembly" is..

Then I guess you have it all covered re. the turn signals. I'm from the "old school" of guys who prefer original equipment.

Sounds like you have a leak at the manual shaft seal, Which is an "O" ring. Actually two "O" rings since the kick down lever is inside the manual shaft. I have replaced these seals in the past; the biggest problem is getting the detent pin and spring back into place. My recommendation is to...

It does appear to be a mixture of parts. I don't believe I can see the passenger side assist bar. Would you mind posting the Vehicle Identification Number?

Searching for a AM/FM radio for a 1963 Thunderbird. Seeking an original Ford radio. It need not be in working condition. [email protected]

^^ sits too low I'd say new rear springs or load-leveler shocks. New springs would be best.

I would say "left side of the steering wheel". It's actually mounted on the lower edge of the dash panel; held in place by only one screw. The electrical plug has the two slots for the two switch blades in a "T" formation.

Vacuum Check Valve The Ford part number for the vacuum check valve is C6OZ-19A563-A. It does not look like the original. (May be available from your Ford dealer.) Concerning the vacuum can behind the RH headlight: if there was one previously installed, you should see three holes beside the...

Anti-squeak pads These pads are installed between the leaves of the spring and they fit into a depression on the lower of the two leaves (I think).

I believe what you are seeing is a fusable link; installed there to burn in two before major damage is caused by an electrical overload. I think it is shown in Fig.6 page 22-10 (1966 shop manual) and only identified as "FUSE ASSY". [Shown between ignition switch and 60-AMP CIRCUIT BREAKER]...

Upholstry material Veteran's Supply in Houston, TX has an extensive inventory of auto upholstry fabrics.