Changing the window motor on a 65 Tbird

[Jerry Byers]

I need to replace the passenger side, front window motor. I assume I will need to remove the glass, which I know how to do and then remove the entire regulator assembly with the motor attached in order to get to the motor to remove it and replace it.

Is this correct?

If so, how exactly, once I have removed the window, do I remove the regulator? The shop manual is not real clear as to which screws to remove, etc.........

Any help would be greatly appreciated........

Jerry

 

[redbird1]

I would assume your 65 is like my 66 so, removing the window is not necessary.
Once the door panel is removed, you will see four bolts in close proximity to the
"cup you put your hand in to close the door once you are in the car.
These four bolts attach the gear assembly, and motor to the door panel.
On the left of the same "cup", you will see tow bolts.
These bolt the window track on the left too the door panel.
Remove them, and reach up inside and remove that small section of track from the door panel, and the roller from the window glass itself.
You will now be able by hand, to push the window up to free the rollers from the track.
They you can slide the motor, and gear assembly out as one unit.
Once the assembly is out, lower the window to protect it from dropping and damaging the glass.
Bob.

 

[Jerry Byers]

Thanks Bob

Great info. I guessed right about the four bolts, but I would have missed removing the window track..........

Thanks for your prompt response. I have my work cut out for me on the weekend now.............