Search results

I am installing a autolite 4100 carburetor on my 66 Bird. The carb spacer is wedged shaped...appx 1/2" down to an 1/8". Does the thin side face the front of the car or vice versa. - Thanks

Looking for a carburator spacer for a holly 4100 4bbl. My current one is tapered ... 4 hole - roughly 1/2" down to 1/4" - thx John

do i need a paper gasket on the manifold between the spacer plate...and a composite gasket from the spacer to the carb.?

What is the correct spark plug and gap for a 390 6.4

I'm looking for a fuel pump replacement on my 390. I want one that's manufactured in the USA. -Thanks, John

I'm getting a very slow oil-like drip out of the right side fresh air outlet in my '66. It's yellowish in color. I'm confused..any thoughts? Thanks, John

Can anyone tell me how much vacuum is needed to operate the heater control valve. Thanks, - John

I'm getting 10# vacuum pressure to the heater control valve. Is that enough to operate it properly? Thanks, - John

Was cleaning up the floormat on the driver side and noticed a disconnected hose hanging over the gas pedal. The black rubber hose measures 5/32" ID. Can't see where it goes. Car is running good. Any help would be appreciated. - Thanks John '66 Convert

How can I bench test a fuel sending unit? -Thanks

Mark, What color is the interior? - Thanks, John

Hello, I have a 66 Convert with a very good interior...except for a tear in the center of the bottom cushion of the front passenger seat. Trim #27 Aqua. After 51 years the vinyl is still supple, but the sun,wear,dirt, etc have given the interior a patina that does not match any of the available...

My front and rear turn signals are working, however the indicators on the fenders are not. If one bulb is blown, will it cancel out both sides? Thanks-

390 Misfire Thanks Terry....your post resolved my issue. John

Have newly rebuilt 390 with 2000 miles on it. Has new plugs, wires, points, condenser, vacuum advance. Timing, dwell, points, and plugs are all within spec. Cap and rotor appear to be in excellent condition. Checked running motor at night .... no fireworks. Engine has a miss at idle and...

Approximately how many rpms will my stock 390 will be turning at 60 mph. 1966 Tbird with 215/75R15 tires. Thanks, John

I'm rebuilding my 390. Should I consider a high volume oil pump. Thanks, John

I have a York A/C compressor in my '66 that needs a new crankshaft seal kit. I pulled the clutch pulley and old seals. I believe it is a long stroke. I'm having a difficulty finding the correct kit as I'm not 100% sure this is the original compressor. The numbers stamped on the case tag are...

1966/390 Can anyone tell me the inside diameter of the ac hose that runs from the dryer/receiver to the condenser? Appreciate it, John G.

I get to answer my own question for this particular issue... A relatively easy fix. The floats were set too high. Runs much better now.