|
I have the ignitor instructions in front of me and it says the red and black wires go to the coil, and the remainingh wire goes from the distributor to the ignition switch (for cars without Ballast Resistor).
However, in the FAQ section, it says:
"How do I correct a low voltage problem?"
"First, if you have an external ballast resistor, connect the red ignitor wire to the ignition wire prior to the ballast resistor. Second, if you do not have a ballast resistor you must locate a 12-volt source that is controlled by the ignition switch to connect the red ignitor wire to."
The power window relay on the firewall should be a "on the key" 12V source, right? Where does your red wire from the Ignitor go Joe?
|