|
There should be some pins that look like nailheads that the clips fasten to. The new clips will be a little tight at frist but that is what you want. When new top goes on fold the edge down so it goes under pin and pin protrudes threw top, this will secure the top. Put glue in channel so viinyl will stick. Here is where you don't want a lot of excess, so cut off what is not needed before gluing. The window channels, throw those wore out screws away and put proper size pop rivet in holes where screws came out. Remember outer channel around window covers the vintl also fit so they hold new top down, after a good fit is done, put rivets in to hold in place. Door gasket tray has a seal under it also, parts store has stick on weather strip, get 1" wide tape and stick to its back before putting this back on, then door gasket. If door gasket is bad replace it will keep wind noise down and car cooled if not leaking.Buster
|